These instructions are for those who have the Internal USB download option in their EDM.

After the EDM has finished its Self Test and after tapping the ‘Step’ button to get past the “Fill? N” prompt (if a FF model) – insert the USB flash drive. Now the EDM will automatically go to PROGRAM and then to DUMP NEW after a few seconds. Tap the ‘LeanFind’ button to choose either ‘DUMP NEW’ or ‘DUMP ALL’. Now tap the ‘Step’ button to start the download. You should see the EDM counting down if your EDM’s memory is full and you choose DUMP ALL. After it has finished you will see “WAIT USB”. Wait 5 seconds or so until you see “DONE” on the EDM. This message will last about a second or two. When the word ‘DONE’ disappears and the EDM goes back to displaying normal temperature data, you can then pull out the flash drive. Use Eztrends (*) software on you home or office PC to plot you flight data.

* Go to: https://www.jpinstruments.com/technical-support/software-downloads/to download the latest Eztrends software. Be sure to stay on-line while you install it.